![]() ![]() This is also something we're aware of, please check #8578.Īnyway, since classic perimeter generation is still a feature in PS, we will probably keep this issue open until we can improve on it. If you’re relying on your slicer’s automatic ‘Generate Supports’ command, then this will likely be the basis for the placement and number of supports. Good exterior surface finish though compared to the lumpiness I got with gap fill. The usual rule of thumb in 3D printing is that any overhanging feature that is angled more than 45 degrees from the vertical will need to be reinforced with a support structure. I print a thin-walled tube with Arachne and end up with two perimeters that don't touch each other when printed, and the whole thing crumbles when squeezed. Please refer to #8443, #8512, #8686 and #8841 (we will close some of these soon to keep discussion to one thread). We are currently working on seam placement when using Arachne, so this should be fixed soon. I expected it to do gap filling where needed if it makes gaps, but it doesnt do that, making for really ugly finishes. The video shows some intelligent features for improving top layers and overhangs if you. Im trying to make some decorative knobs for electronics, and somehow the knobs with a D-shape in the middle make for an uneven concentric shape that needs to be fixed at some point. Filament diameter is set to 1.75 and my filament measurements are exactly 1.75. SuperSlicer can upload to WiFi printers and has some infill and support options that were not in Simplif圓D. ![]() I use this for work so unfortunately the aesthetics matter. Extrusion multiplier for three-perimeter, 0.7mm extrusion width is spot on at 1.93mm. ![]() The perimeters trace the outline of your part creating a. The ring of ripples on the part from overzealous gap fill is gone, but features that formerly came out crisp are a little rougher this time around. Each layer of your 3D printed part is created using a combination of outline perimeters and infill. Just tried a print Arachne has already fucked up my seam placement (I selected “rear” but got diagonal) and seems to have poorer dimensional stability. Enable Auto Speed (set all speed settings to 0 under Print Settings -> Speed, set your maximum speeds at the bottom of the same page) Slice one file with gap fill set to 0 (gap fill disabled) Slice another with it set to a fair number for your printer (I used 50mm/s) Compare estimated print time / output gcode. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |